- Bits - Myler
- Bridles - Reins
- Endurance - Trekking
- Halters - Lead Ropes
- Hidez Compression
- Horse Boots - Bandages
- Horse Rugs - Covers
- Luggage - Gear Bags
- Lunge Equipment
- Racing - Flat Racing
- Racing - Harness
- Rider Attire
- Saddle Accessories
- Saddles - Saddle Cellar
- Stable Accessories
- Travel Protection
MYLER WESTRN DEE WITH HOOKS MB43LP
Approx $184.46 USD
NOTE: SPECIAL ORDER, PLEASE ENQUIRE FOR AN ETA.
Myler Stainless Steel Western Dee with Hooks
MP 43LP Narrow Low Ported Barrel
The MB 43LP does not rotate on to the tongue, but instead sits solidly across the bars and lips of the horse’s mouth. The port is narrower than a Level 3 mouthpiece, but still offers room for the horse’s tongue to pass under the bit. Because the port is narrow, when the reins are engaged, the horse will feel a slight pressure on the outside edges of the tongue — a gentle reminder rather than a strong reprimand. The port on this mouthpiece is only 1 ¼" high, so it will apply little to no palate pressure. It is the mildest of the Level 2-3 mouthpieces in terms of tongue pressure, just one step below a Level 3 mouthpiece. Sweet iron mouthpiece oxidizes and encourages salivation.
- Independent Side Movement
- Sweet Iron mouthpiece
- Curved Mouthpiece does not pinch lips and bars
- Copper Inlay
The Western Dee with Hooks is a circular stainless steel ring with fixed attachment of the mouthpiece, with top and bottom rings (“hooks”) for headstall and rein attachment. The small loop behind the top slot accommodates a curb strap (attach with two curb hooks). The top bridle ring will fit standard ⅝" leather found on most headstalls. The bottom rein ring has recently been updated to fit slobber straps up to approximately 1 ¾". The knob on the top of the rein ring is for decoration—it has no function.
The hooks make this a much more versatile version of the dee without hooks. Attaching the headstall to the top hook holds the bit in the correct position instead of allowing it to slide around the bridle cheek pieces. Attaching the reins to the rein hooks allow the rider to lift the cheek and use the Independent Side Movement™ of the mouthpiece. Using the hooks does not add leverage but allows the rider to transition from a direct rein action to indirect action without changing the bit. Adding a curb strap (using a Myler curb strap kit) incorporates curb pressure. Curb pressure is recommended for ported mouthpieces.
Size: 3" offset ring
Action: Direct rein action when reins are not attached through rein hook. Indirect rein action when rein is fixed on rein hook.
Discipline: Primarily Western
Degree of Leverage: Little to no leverage when the hooks are used
*You are seeing a brand new design for this cheekpiece. Please be aware that you may receive the original design.